Pioneer DVR-A06 Mode D'emploi page 7

INTERFACE
FRONT VIEW
1
1 Forced Ejection Hole
Insert a stiff rod into the hole and push to eject the tray when the tray doesn't unload by
pressing the Eject button. In the normal operation, the eject button should be used to unload
the tray. Make sure the power of the drive is turned off and wait more than one minute till the
disc rotation is stopped when access the eject hole.
2 BUSY Indicator
Operation status is indicated as follows.
During reading
During writing
3 Ventilation Hole
Do not block this part.
4 Eject Button (0)
To unload /load the disc, press the button.
5 Disc Tray
Open the loading tray by pressing the eject button, then place a CD or DVD disc into the slit
with the label facing up.
Press the eject button or push the front part of tray to load the tray with the disc.
Do not attempt to pull out the disc tray forcibly.
Precautions on playing 8 cm (3.15") Discs
An 8 cm (3.15") disc cannot be played even an adapter is attached to the disc when the drive is
upright condition.
ABOUT REGION CODES
The region code can be changed ONLY 5 times, including the 1st setting. Please be
aware the 5th change will be PERMANENT, therefore, please pay attention when
changing region codes.
÷ Region codes are part of the DVD Standard. However, Region codes on DVD
discs are optional. DVD discs with no specified Region code can be played on all
players.
BUSY
2 3
Lights
Lights
4 5
En
7