Carson Reflex Wheel LCD Mode D'emploi page 19

BEC-System/Connections to Receiver
BEC-receiver:
Battery eliminator is installed in the receiver
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
Electronic speed controller
(not included)
Receiver
Do not connect a separate power
supply to the receiver!
Equipment for Combustion Engine
Receiver Batteries and two servos are not included in the kit.
Receiver
Make sure to connect in
correct direction.
Receiver battery
case NiMH-batteries
item No. 50 060 9000
are recommended
Receiver switch
CARSON Reflex Wheel LCD 2.4 GHz 50 050 0031
the receiver. Batteries of higher voltage may
damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
Connector motor
Connector battery
Power Switch On-/Off
Steering servo
Channel 1
(not included)
ATTENTION
Make sure that male and female connectors
have the correct polarity.
Servo channel 3
Throttle servo Channel 2
(not included)
Steering servo Channel 1
(not included)
ATTENTION
When connecting servo leads to the receiver
always ensure that the yellow lead/wire is
facing inwards (towards the crystal).
GB
19