Milwaukee 303B Manuel De L'utilisateur page 3

SPECIFICATIONS
Cat. No. ............................................... 303B, 333B
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
FUNCTIONAL DESCRIPTION
2
3
4
5
1. Power button
High: Red LED
Medium: White LED
Low: Blue LED
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body
of the battery holder. Make sure it latches securely
into place.
Insert the power cable (from inside the battery holder
pocket) into the power cable port on the battery holder.
Place the battery holder into the pocket and press
pocket closed.
To remove the battery, push in the release buttons
and pull the battery pack away from the holder.
OPERATION
The power button is located on the upper left side
of the vest.
To turn on, press and hold the heated vest power
button (1 to 2 seconds). The vest will be turned to
High and the red LED will light.
Temperature setting can be adjusted at any time by
pressing the heated vest power button. Each press
will cycle through the heated vest's temperature
settings.
To turn off the heated vest, press and hold the
heated vest power button until the LED turns off (1
to 2 seconds).
If the heated vest turns off unexpectedly, check con-
nections and charge the battery pack.
43-72-1000
2
2. Battery holder
3. Power cable port
4. Power cable
5. Battery holder pocket
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery pack and battery holder from the heated
vest before performing any maintenance. Never
disassemble the heated vest, battery pack or
charger. Contact a MILWAUKEE service facility
for ALL repairs.
If the heated vest does not start or operate properly
with a fully charged battery pack, clean the contacts
on the battery pack. If the heated vest still does not
work properly, return the heated vest, charger and
battery pack, to a MILWAUKEE service facility for
repairs.
To reduce the risk of personal in-
WARNING
1
jury and damage, disconnect and
remove battery pack and battery holder from
battery holder pocket before washing. Never im-
merse your battery holder, battery pack, or
charger in liquid or allow a liquid to flow inside
them.
To clean the heated vest:
1. Remove battery pack and battery holder.
2. Push the power cord completely into the battery
holder pocket and fasten closed.
3. Machine wash, Gentle Cycle in warm water. Do
not use bleach. Do not dry clean. Do not wring or
twist.
4. Tumble Dry on Low Heat. Do not iron.
Use only recommended accesso-
WARNING
ries. Others may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
SERVICE - UNITED STATES
1-800-SAWDUST
Monday-Friday, 7:00 AM - 6:30 PM CST
www.milwaukeetool.com
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
SERVICE - CANADA
Milwaukee Tool (Canada) Ltd
Monday-Friday, 7:00 AM - 4:30 PM CST
or visit www.milwaukeetool.ca
LIMITED WARRANTY
USA & CANADA
Every MILWAUKEE M12 HEATED JACKET (including its battery holder)
is warranted to the original purchaser only to be free from defects in
material and workmanship. Subject to certain exceptions, MILWAUKEE
will repair or replace any part on M12™ Heated Jacket which, after
examination, is determined by MILWAUKEE to be defective in material
or workmanship for a period of one (1) year* after the date of purchase.
Return of the Heated Jacket to a MILWAUKEE factory Service Center
location, freight prepaid and insured, is required. A copy of the proof
of purchase should be included with the return product. This warranty
does not apply to damage that MILWAUKEE determines to be from
repairs made or attempted by anyone other than MILWAUKEE person-
nel, misuse, alterations, abuse, normal wear and tear, or accidents.
*This warranty does not cover a M12™ LITHIUM-ION Battery Pack;
there is a separate and distinct warranty available for a battery pack.
3
CARE
ACCESSORIES
(1.800.729.3878)
1.800.268.4015