Genie 106 S Vario Mode D'emploi page 8

paper jam may result. After the paper has been fed into the shredding slot, the document
shredder will deactivate automatically.
Only insert paper into the designated feed slots!
2. REV (reverse operation): "REV" make the cutting unit turn backward. With these function
paper jams can be removed (please refer to chapter "Protection against paper jams and
overloading").
3. OFF position is recommended when emptying the wastebasket or when the shredder is
not in use for a prolonged period of time.
4. CLEAR button: Press it when the cutting process ends and there is still some paper in the
cutting unit. Using the Clear-switch the engine will start and the remaining paper will fully
ejected into the waste basket.
Capacity of the document shredder:
The 106 S Vario shreds up to 6 sheets of paper (DIN A4, 80g). The paper width may comprise up
to 21.8 cm. When shredding small paper sizes such as letters or credit card receipts, please
insert them into the middle of the shredding slot.
Please ensure that never more than the above-mentioned maximum quantity is inserted in
the shredder. Otherwise the device may sustain damage.
Protection against paper jams and overloading:
The 106 S Vario is equipped with a motor overload guard. To protect the machine well, we
suggest the user to operate it in this way: work 2 minutes then rest 60 minutes. Under the
following conditions, the current feed to the unit's motor is interrupted:
•
Continual operation of the document shredder with maximum capacity for a prolonged
period of time, e.g. longer than 2 minutes without interruption.
•
Overrunning the shredding capacity e.g. adding more than 6 sheets of paper (80g) in one
operation or in the event the paper is not inserted length-wise into the feed slot.
Under the above-mentioned conditions, the automatic overload guard of the motor is triggered,
whereupon the current feed to the device is interrupted. In such a case, please take the following
steps:
1. Disconnect the main plug from the AC socket in order to avoid the risk of serious injuries and
wait at least 60 minutes until the overload guard has reset. Now tear off excess paper from
the top of the shredder or remove it.
2. Reconnect the main plug to the AC socket and switch to REV. Pull the remaining paper
away from the shredding blades. If necessary, repeat this step.
Technical data:
Shredding type:
Size of cut:
Shredding capacity:
Feed width:
Input voltage:
Dimensions:
Noise level:
Strip-cut
6 mm (paper)
6 pages DIN A4 (80g)
approx. 220 mm
220~240 VAC, 50 Hz, 0,9A
approx. 310 x 105 x 90 mm
approx. 72 dB
- 8 -