Additional Information; Specifications - Pioneer GM-D7500M Mode D'emploi

Appendix

Additional information

Specifications

Power source ............................. 14.4 V DC (10.8 V to 15.1 V
Grounding system ................... Negative type
Current consumption ............ 18 A (at continuous power,
Average current drawn ......... 5.2 A (4 W for one channel)
Fuse ................................................ 40 A × 1
Dimensions (W × H × D) ... 245 × 56 × 200 mm
Weight .......................................... 2.1 kg (4.6 lbs)
Maximum power output ....... 400 W × 1 (4 W) / 800 W × 1
Continuous power output ... 200 W × 1 (at 14.4 V, 4 W, 20
Load impedance ...................... 4 W (2 W to 8 W allowable)
Frequency response ............... 10 Hz to 30 kHz (+0 dB, -3
Signal-to-noise ratio ............... 95 dB (IHF-A network)
Distortion ..................................... 0.03 % (10 W, 100 Hz)
Low pass filter:
Cut off frequency ........... 40 Hz to 240 Hz
Cut off slope ..................... -12 dB/oct
Bass boost:
Frequency .......................... 50 Hz
Level ..................................... 0 dB / 6 dB / 12 dB
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 10 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 22 kW
Speaker .............................. 10 V / 22 kW
CEA2006 Specifications
12
En
allowable)
4 W)
10.3 A (2 W for one channel)
(9-5/8 × 2-1/4 × 7-7/8 in.)
(Leads for wiring not in-
cluded)
(2 W)
Hz to 240 Hz, ≦ 1% THD)
400 W × 1 (at 14.4 V, 2 W, 50
Hz, ≦ 1% THD)
dB)
Power output ............................. 200 W RMS × 1 Channel (at
S/N ratio ....................................... 72 dBA (reference: 1 W into
Notes
! Specifications and the design are subject to
modifications without notice.
! The average current drawn is nearly the maxi-
mum current drawn by this unit when an
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.
14.4 V, 4 W, 20 Hz to 240 Hz
and ≦ 1 % THD+N)
400 W RMS × 1 Channel (at
14.4 V, 2 W, 50Hz and ≦ 1 %
THD+N)
4 W)