Safety Instructions - erba 18021 Mode D'emploi

GB - INSTRUCTION MANUAL

1. SAFETY INSTRUCTIONS

Read this material before using this product. Failure to do so can result in serious injury. KEEP THIS
MANUAL. When giving this machine to third parties, always include this manual. We do not accept
any liabilities for accidents or damages that result from misuse. Removal/Alteration of any
safety devices or of the machine in general will result in the loss of warranty. The
buyer assumes all risk and liability arising out of his or her repairs/alterations to the
original product or replacement parts thereto, or arising out of his or her installation
of replacement parts thereto.
Prior to first use put a few drops of oil in the air coupling of the machine to ensure sufficient
lubrication.
Install an air filter, pressure regulator and a oiler between the machine and the source of com-
pressedair. The filter will keep condensate and dirt from entering the machine and the oiler
will keep the tool lubricated. With the pressure regulator you can regulate the amount of air
pressure.
Air tools that are not sufficiently oiled during operation may become damaged and such dama-
ges are exempt from any warranty claims.
The air hose must be fitted with quick-couplings, so that it can be quickly removed in an
emergency.
Only use ils that are designed for use in air tools (like ERBA Art. Nr. 18200). Do not use regular
motoroil!
The working pressure must not exceed 6,3 bar.
Use seperate air hoses for tools that require lubrication (like ratchet wrenches, impact wren-
ches, etc.) and tools that do not (like spray guns, dust guns, etc.) to avoid contamination of
spraypaint or surfaces with residual oil from the hose.
Use hoses with suitable inner diameter (6-9mm) for maximum efficiency.
Do not connect more than two air tools to the same air supply at the same time.
If the tool is stored for longer periods of time, put a few drops of oil in the air coupling of the tool
and operate the tool for a few seconds so that all internal parts are well lubricated for storage.
Always disconnect the air-hose when performing any kind of maintainance work on the tool.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 9
Changes, print, punctuation and other errors reserved!
Instruction manual
18021
Issue: 06/2017