Important Information For Initial Operation; Operation Instructions; Service And Replacement Parts; Warranty - erba 18045 Mode D'emploi

GB - INSTRUCTION MANUAL

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

See operation instructions.

8. OPERATION INSTRUCTIONS

Please not that for any maintainance work or tool changes the air powered saw must be
disconnected from the air supply to avoid serious injury!
Remove the protective cap from the air coupling (3) of the saw.
Screw the euro adapter into the air coupling.
Use teflon tape on the thread of the adapter for proper sealing.
Open the tool holder (1) with the supplied hex keys (6) and put in the required sawblade.
Fasten the tool holder again and connect the saw to the air compressor.
Make sure to install a pressure-regulator between the saw and the compressor so you can
adjust the working pressure (max. 6,3 bar).
To start the air powered saw push the on/off switch (2).

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
18045
Issue: 06/2018