Clock Operation; Setting The Clock - Coby CRA79 Mode D'emploi

Clock Operation

Setting the Clock

1. Set the SETTING switch (5) to the TIME position.
2. To set the hour, rotate the set dial clockwise until the
correct hour displays.
3. To set the minute, rotate the set dial counterclock-
wise until the correct minute displays.
4. Once the time is displayed correctly, move the
SETTING switch to the RUN position to confirm. The
display will stop flashing.
Setting the Projector
Note: This feature creates a time display projection on
the ceiling or wall or a darkened room. The projector
clock operates independently of the rest of the unit;
setting the digital time display will not affect the projec-
tor display time. You must set the projector display
time manually.
1. Extend the projector unit and aim the front lens at
a wall or other surface. Adjust the FOCUS knob until
the projected display appears in focus. You may need
to dim the lights in order to see the display clearly.
2. To set the hour, hold down the T (time) button while
simultaneously pressing the H (hour) button until the
desired hour is displayed.
3. To set the minute, hold down the T (time) button
while simultaneously pressing the M (minute) button
until the desired minute is displayed.
Page 6 Coby Electronics Corporation