Samsung HT-H5500 Mode D'emploi page 10

Connections
Installing the Speakers on the Tallboy Stand
* HT-H5530/HT-H5550/HT-H5550W only
Turn the Stand Base upside-down and
1.
connect it to the Stand.
2. Use the driver to combine the screws on the
3 marked holes.
3. Straighten a supplied speaker wire to the
gravity direction and put in the hole on the
centre of Stand Base.
Connect the upper Speaker to the assembled
4.
Stand.
Insert a screw clockwise into the hole on the
5.
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
Speaker Cable Connections
Match each speaker cable bundle to the correct speaker by matching the colour coded plug on each
1.
bundle to the coloured sticker on the bottom of each speaker.
Connect the speaker wire plugs from each speaker to the back of the product by matching the colours of
2.
the speaker plugs to the colours of the speaker jacks.
1
Stand Base
Stand
3
5
10
- English
2
4
Speaker
Stand
6