Care And Cleaning - Toto MW604584CEFG Manuel D'installation

1) Shut off the water supply.
2) Flush the toilet to remove the water
inside the tank.
3) Remove the tank lid and place
somewhere safe.
NOTE: Before removing anything from
the tank, note the placement of the
drain valve, chain and refill tube.
4) Unhook the refill tube from the
overflow tube of the drain valve.
5) Unlock the flush tower unit by turning
counter-clockwise with the chain hook
still attached to the trip lever (ill.1).
6) Unhook the chain from the trip lever
and remove the flush tower unit (ill. 2).
7) Unscrew the three screws from the
drain valve body.
IMPORTANT: Make sure not to turn
more than seven full turns as the black
mounting block can fall into the water
channel.
8) Remove the drain valve body from the
tank (ill. 3).
9) Replace the drain valve in the same
position as the former drain valve.
10) Tighten the screws, applying light
torque on each screw before final
torque on all three screws.
11) Install the flush tower unit onto the
drain valve body and turn clockwise to
lock the part.
12) Hook the chain back to its original
location, and the refill tube.
13) Turn the water supply back on and
check for any leak after the tank has
been filled.
WARNING!
DO NOT USE IN-TANK BOWLCLEANERS.
The use of high concentration of chlorine or chlorine-related products can seriously
damage fittings in the tank. This damage can cause leakage and property damage.
TOTO shall not be responsible or liable for any tank fitting failure or damage caused
by the use of in-tank bowl cleaners.
MAINTENANCE INSTRUCTIONS
Replacing the Drain Valve

CARE AND CLEANING

ill. 1
Flush Tower
ill. 2
ill. 3
7
Refill Tube
Overflow
Tube
Drain Valve
Drain Valve
Body