Set Temperature; Using The Device Without Power; Using The Device In A Car (Battery Protection) - MAGIRA CUBA CB18-C Manuel D'utilisation

3.4 Set Temperature

To set the temperature in the cooling zone, press the
temperature control +/-

3.5 Using the Device Without Power

Please ensure an uninterrupted power supply during operation.
The device is not designed for operation without power
supply and can only keep its temperature to a limited time,
depending on the outside temperature.

3.6 Using the Device in a Car (Battery Protection)

The device is equipped with a three-stage battery protection.
To protect your battery, the device switches off when the
battery voltage falls below the respective battery voltage.
Use the High mode if you have connected the device to
•
your starter battery
• Use the Medium mode if you have connected the device
to your starter battery and the conditions are good (e.g. no
severe cold, no severe heat, no long periods of standing)
• Use the Low mode only when using separate supply batte-
ries to ensure vehicle starting. If this mode is used when
connected to the starter battery, it may not be possible to
start the vehicle
Adjustment:
Press the SET button
currently set mode (H, M or L) flashes.
Then press the SET button
mode.
32
11
10
for at least 3 seconds until the
10
again to switch the desired