ICE AIR HHW Série Guide D'utilisation Et D'entretien page 12

Roomside Component Cleaning
IMPORTANT: Power MUST be disconnected
before carrying out any of the following
cleaning!
To access the components within the chassis
of the unit:
1. Unit must be in OFF Position.
2. Disconnect unit from power source.
3. Remove the unit front cover/access
door by unscrewing the retaining screws
that hold it in place. You will then have
access to the unit components.
NOTE: Pictures of components and parts
may vary depending on your model.
Air Filter
1. Remove Permanent Air Filter.
2. Wash Air Filter in warm water and
biodegradable cleaner.
3. Rinse with clean water and allow to dry
completely.
4. Replace Air Filter.
5. As an alternate cleaning method, the
filter may be cleaned on both sides using
a vacuum cleaner and a soft brush type
attachment.
IMPORTANT: Do not operate unit without
filters.
Precautions and preparations listed are for general knowledge and to define basic guidelines. Local codes and existing practices should be observed and preformed by a professional.
Due to ICE AIRs ongoing product development programs, the information in this document is subject to change without notice.
Evaporator Coil
Check the coil for cleanliness and uniformity
of fins. If the coil is dirty, vacuum clean with
a soft brush attachment. This is the only form
of cleaning that should be carried out within
an apartment. If the coil requires additional
cleaning, the unit must be removed and
cleaned using compressed air and/or
washed. These operations MUST be carried
out in a facility properly equipped to handle
this type of work in a safe and professional
manner.
12
Evaporator Motor and Blower Assembly
If there is evidence of dirt or dust build-up in
the evaporator motor or blowers, they should
be cleaned either by vacuum cleaning (if
working in an apartment) or by removing the
unit to a workshop location and cleaning with
compressed air.
p WARNING: Always obey safety
!
guidelines for using compressed air
in this latter case.
Your ICE AIR unit has permanently lubricated
motor bearings that do not require additional
lubrication. Blowers and motors are factory
assembled for quiet performance – if there
is any excessive noise and vibration from this
assembly, it should be serviced by a qualified
technician.
Condenser (Water
Heat Exchanger)
Generally, if water
flow exceeds 3 gpm
per ton, the water
velocities should
keep your coil free of
scaling of debris that
could lead to erosion
and fouling.