HDS Technology SERENE TV Direct TV-100 Guide D'utilisation page 7

CONNECTINg ThE TRANSMITTER TO YOUR Tv, CABlE BOx, OR
OThER SOUNd SOURCE
Option 2 Same procedures as Option 1 except that you connect the transmitter through
the headphone port (usually located at the front of your TV). If you connect it to
the headphone port, adjust the volume of the headphone output to a medium
level. If this connection mutes the TV speaker sound, you can deactivate the mut-
ing function by using the TV menu setting
If your TV does not have a headphone or audio output jacks, you can place an
Option 3
optional microphone module directly in front of your TV loudspeaker to pick up the
sound for transmission. Connect the other end of the microphone module to "Audio-
in" on the rear of the transmitter base. Set the Selector switch to the MIC position.
(This optional microphone module is available from a Serene Dealer).
Option 1 (Recommended)
1. Set the Selector switch on the transmitter
base to Stereo mode.
2. Use the provided audio cable (and audio
adapter) to connect "Audio-in" on the trans-
mitter base to the audio jacks of your TV (or
cable box) as shown.
3. Set the TV volume to a comfortable level. On
many TV sets, you may "Mute" the TV speaker
output and still be able to hear via TV-Direct.
4. Press the transmitter On / Off switch to turn
on the power. Verify the IR diodes are glowing
faintly behind the IR transmitter window.