Télécharger Imprimer la page

Ermax EM1786 Notice De Montage page 2

Publicité

Les langues disponibles

Les langues disponibles

– Z.A
1074, A
C
VENUE DES
ARRIERES
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - e-mail : accueil@ermax.fr
Fitting kit
- 3 screws BHc 5×25 (big head)
- 3 « silent block » with steel spacers
- 1 rubber insert M5
Fitting instructions
- Remove both screws that secure the meter cover. Place the « silent block » on the nose screen (the
metallic spacer flange is placed outside the nose screen).
- Position the nose screen on the motorbike and secure it with 2 screws BHc 5×25 on the meter cover
fixations.
- Through the last « silent block », locate the hole to drill in the meter cover, and then remove the nose
screen.
- For added safety, remove the meter cover by removing the 2 screws holding next to the turn signals.
Drill the cover on the mark spot previously to diameter 9.5mm.
- Replace the meter cover. Fit it with the original screws at the indicators level. Place the rubber insert in
the hole drilled previously.
- Place the nose screen on the motorcycle and fit it thanks to the 3 screws BHc 5×25. Tighten gradually
and finish tightening starting by the bottom screw.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
P
C
III
LA
LAINE DU
AIRE
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN - NOSE FAIRING
ADAPTABLE ON SV 650 N 2016 → ∞
« CAUTION »
Update : 19/01/16
Estimated mounting time: 30 mn
Drilling to perform at Ø9,5 mm
EN

Publicité

loading