To Clean The Collection Blades - Ionic Pro pro copmpact CA200 Manuel De L'utilisateur

CLEANING & MAINTENANCE
CA200
Helpful Tips: Remember to clean your Ionic
Pro® Compact ionic air purifier every month and
any time the red CLEAN / FAULT light comes on
or whenever you hear your unit begin to make
excessive noise.

To Clean the Collection Blades

Turn off and unplug your Ionic Pro® Compact air
purifier. Let the unit rest a minute.
Next, lift off the removable cap and pull up on the
collection blades' handle to slide the collection
blades out of the top of your Ionic Pro® ionic air
purifier.
Do not touch the metal blades until after discharging
residual electricity by touching blades to an electrical
ground such as a water pipe or metal faucet. Wipe
away the trapped particles collected on the three
blades with a slightly damp sponge or cloth. If you
use a slightly damp cloth to clean the blades, it is
possible the collection blades will be completely dry
within two to three hours. Always allow the collection
blades to dry thoroughly before resuming use.
IMPORTANT: To avoid damaging your Ionic
Pro® Compact ionic air purifier, make sure the
collection blades are completely dry and free of
all moisture and that your Ionic Pro® Compact
ionic air purifier is turned off and unplugged
before attempting to re-insert the collection
blades.
If you have used soap and water to clean the
collection blades, wait at least 24 hours to ensure that
they are thoroughly dry before re-inserting them into
your Ionic Pro® Compact ionic air purifier.
Collection Blades
14 15
CLEANING & MAINTENANCE
H.
Cleaning the
Ionizing Wires
To Clean the Ionizing Wires
The internal ionizing wires need to be cleaned
after every two weeks of use. There is a Wire
Cleaning Mechanism used to clean the
internal ionizing wires which you slide up
and down to scrape off particle residue, (see
Diagram B of the Operating Panel to locate the
Wire Cleaning Mechanism). Lift and lower the
Wire Cleaning Mechanism three or four times
to thoroughly clean the ionizing wires (see
Diagram H).
REMEMBER TO ALWAYS RETURN THE WIRE
CLEANING MECHANISM TO ITS ORIGINAL
POSITION BEFORE ATTEMPTING TO RESUME
USE OR THE UNIT WILL NOT FUNCTION.
CA200