Samlex Solar SSP-100-KIT Manuel De L'utilisateur page 9

Fig.3.5 above shows an arrangement for connecting second solar panel in parallel that is separated by an
extended distance. In this case, the following will be required:
• SCW-20-2 Connecting Wires Kit - 2 sets (one set is provided with this kit. Second set has to be ordered
separately)
• One MC4 Male Branch Connector and one MC4 Female Branch Connector sold separately as an optional
kit – Model No. "SBC-2" Kit
• One MC4 Male Connector and one MC4 Female Connector sold separately as an optional kit – Model No.
"MC4-2"
In this case, one Connecting Wire Kit "SWC-20-2" and the optional MC-4 Connectors Kit "MC4-2" are first used
to bridge the extended distance between the panels. The optional Branch Connector "SBC-2" Kit is used to
parallel the two solar panels. The second Connecting Wire Kit "SWC-20-2" is used to connect to the Charge
Controller (not supplied).
CONNECTOR SYSTEM FOR CONNECTING SOLAR PANELS
3
9 9