Braun AB 65 Mode D'emploi page 8

Should contact to the radio signal be restored, the time
will automatically be adjusted according to the signal
received.
Setting the time manually
In the case of no reception during 10 minutes or if you
wish to set the time before reception, press the time
button (6) in the battery compartment.
– Press the time button repeatedly to move the minute
hand by minute steps.
– Keep the time button pressed down longer than
3 seconds to move the hands with increased speed.
With the next valid reception of the time signal, the time
will be adjusted automatically.
The clock may also be operated as a regular quartz
clock. If you press the time button (6) while inserting the
battery, the clock will work on its quartz mode and not
receive any radio signal. Use the time button to set the
time. In order re-activate the radio control feature,
press the reset button (5) in the battery compartment.
Alarm function
The alarm set button (2) can only be turned in the
direction of the arrow.
The alarm function is activated by pressing the «alarm
on/off» bar (1).
The blue side of the alarm on/off bar is visible when the
alarm is activated.
Snooze/light function
The snooze/light button (3) is located at the bottom of
the clock housing and will activated when pressing on
the clock housing: The clock face will be illuminated for
8 seconds. When activating the snooze/light button
while an alarm signal is given, the alarm is interrupted
and resumes after 8 minutes.
Battery check system
If the battery is running low, the light flashes. For a
reliable alarm function of the clock, you should insert a
new battery.
As an additional safety precaution, the clock will
generate an error beep when you insert an empty
battery or if you activate the alarm function with a low-
charge battery inserted.
Subject to change without notice.
This product conforms to the European
Directive EMC 89/336/EEC.
At the end of the product's useful life, please
dispose of it at appropriate collection points
provided in your country.
8