Honeywell Home TheraPro HR90 Guide Du Propriétaire page 2

THERAPRO HR90
3. DEVICE OVERVIEW
Operating elements and display
11
10
9
8
1. Heating period/setback period in hours
2. Day of the week 1 ... 7 (Monday ... Sunday). Dis-
played only while the time program is being pro-
grammed
3. Temperature display: e.g. set point temperature
(factory setting) or measured temperature, if
configured in Parameter 9
4. Text display with 9 characters
5. Button OK: Confirm settings
6. Button PROG: Select the operating modes, set
the time program;
Press button >10 seconds: access to the param-
eter menu;
Programming: Back to next level up
7. Adjustment dial: Change the set point, navigate
menu
8. Button AUTO/ECO/MANU: Change between
automatic, ECO and manual mode
In programming mode: Exit (without storing)
9. Battery status
10. Operation lock
11. Symbol for Comfort temperature 1,
Comfort temperature 2, Setback temperature
Battery display
Battery
status
Batteries fully charged
Batteries half charged
Batteries have to be replaced soon
Flashing display: Batteries are dead and
have to be replaced
4. INSTALLATION
Ready to operate in three steps:
• Insert batteries
• Set the language, time and date
• Mount on radiator – FINISHED
33-00084EFS—03
1
2
F
3
4
5
AUTO
PROG
ECO
OK
MANU
6
7
M35568
Meaning
Inserting/changing batteries
The radiator controller is set for the following battery
type:
• 2 alkaline cells 1.5 V; type LR6, AA, AM3
You can instead use the following batteries or
rechargeable batteries:
• Lithium 1.5 V; type LR6, AA, AM3
• NiMH 1.2 V; type LR6, AA, AM3
NOTES:
• If lithium or NiMH batteries are used, Parameter 14
has to be adapted, see Section 9.
• Always change batteries in pairs.
1
3
5
1. Pull off the adjustment dial. To do so, start at the
notch on the bottom of the device.
2. If used, unscrew any fastening screws from the
battery compartment.
3. Release the lock and fold out battery spring.
The battery compartment is now accessible.
4. Insert the batteries.
Ensure that the polarity "+" and "–" is correct.
5. Fold down the battery spring and latch it in.
6. Option: Screw the battery spring to secure the
batteries against removal.
7. Place the adjustment dial back on.
First the software version number and then the
language ENGLISH is displayed.
8. If desired, use the adjustment dial to select a dif-
ferent language.
9. Confirm the selected language with the OK but-
ton. HOUR is displayed.
2
2
OPTION
4
–
+
7
6
OPTION
M35626