Comelit 1456 Manuel Technique page 6

WARNING
• Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the
standards in force.
• All the equipment must only be used for the purpose it was designed for. Comelit Group S.p.A. declines any
responsibility for improper use of the apparatus, for any alterations made by others for any reason or for the use of
non-original accessories or materials.
• All the products comply with the requirements of Directive 2006/95/EC (which replaces Directive 73/23/EEC and
subsequent amendments), as certifi ed by the CE mark they carry.
• Do not route the riser wires in proximity to power supply cables (230/400V).
• Installation, mounting and assistance procedures for electrical devices must only be performed by specialised
electricians.
• Cut off the power supply before carrying out any maintenance work.
Confi guring Art. 1456 / Art. 1456S
1. Power up Art. 1456 / Art. 1456S using Art.1441.
2. Connect Art.1456 / Art. 1456S to your PC via the
HOME 4 port and standard Ethernet cable.
3. Assign the IP address (code identifying a device connected to a network) to your PC: 192.168.1.2
Windows 7
a.
Open Start / Control Panel and select "Network and
Sharing Center".
b.
In "View your active networks" click the connection you
want to edit and select Properties.
c.
In the Networking window, select "Internet Protocol
(TCP/IP)" (or TCP/IPv4 or TCP/IPv6) and click Properties.
d.
Tick "Use the following IP address" and assign the
following parameters:
4. Open your browser, enter 192.168.1.200:8080 in the
address bar and press "Enter".
5. Press "Confi guration".
6. Enter "comelit" in the PASSWORD fi eld and press
Login.
7. Wait for a few seconds.
8. Set the desired language using the drop-down menu
located in the page footer.
6
VIP SYSTEM
Art.1456
FLOOR VIP SYSTEM GATEWAY
SOLO CON CAVO ROSSO COMELIT 2E7T000500
ONLY WITH COMELIT RED CABLE 2E7T000500
FIXED POE SETTABLE POE
HOME 1 HOME 2 HOME 3
Windows 8 and 8.1
a.
On the side bar click "Search".
b.
Search "Network and Sharing Center".
c.
In "View your active networks" click the connection you
want to edit and select Properties.
d.
In the window that opens, click "Properties".
e.
Select Internet Protocol (TCP/IP) (or TCP/IPv4 or TCP/
IPv6) and click Properties.
f.
Tick "Use the following IP address" and assign the
following parameters:
*
the last value must be between 2 and 253
excluding: 200 (assigned to gateway Art. 1456 / Art.
1456S) and the values already assigned to other
devices connected to the network
Art.1441
NO POE
HOME 4
PC
*