Sharp AN-65ST1 Mode D'emploi page 6

Assembling the Table Stand by Using the Packing Material
1
Remove all parts and accessories from the packing
material.
2
Engage the two parts of the material and place
them upside-down.
3
Set the stand/mounting bracket set in the
appropriate grooves in the material.
4
Set the base in the groove and attach it to the
stand/mounting bracket set.
5
Fix the stand to the base using 4 included M6 hex
screws (A). (Use the included M6 hex wrench.)
Align the marks of the
stand/mounting bracket
set to the line on the
bottom of the base.
E-4