Safety And Installation Instructions - Dometic GROUP WAECO PerfectView CAM29S Mode D'emploi

CAM29S
Fig. 1 5, page 3: This refers to an element in an illustration. In this case, item 5 in
figure 1 on page 3.
2

Safety and installation instructions

The manufacturer accepts no liability for damage in the following cases:
 Faulty assembly or connection
 Damage to the product resulting from mechanical influences and excess voltage
 Alterations to the product without express permission from the manufacturer
 Use for purposes other than those described in the operating manual
Please observe the prescribed safety instructions and stipulations from the vehicle
manufacturer and service workshops.
Observe the following installation instructions:
CAUTION!
!
 Secure the parts installed in the vehicle to ensure they cannot become loose
under any circumstances (sudden braking, accidents) and cause injuries to
vehicle occupants.
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be
performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient space on the
other side for the drill head to emerge.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode test lamp or a
voltmeter.
Test lamps with a bulb consume too much voltage, which can damage the
vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear by using cable binders or insulat-
ing tape, for example on existing cables.
EN
Safety and installation instructions
15