Auto Control Or Top Zone; Leds And Pushbutton Actions Fonctionning - JRI Maxant Mini SPY Green Manuel D'utilisation

Full memory: the recorder stops when its memory is full.
With the software: you can put the Mini SPY RF GREEN in standby mode with Sirius when you do not use your recorder.
With the pushbutton: this option is valid only if the Mini SPY RF GREEN is configured in transport mode with a start by pushbutton.
j)

Auto control or top zone

The type of action depends on the Mini SPY RF GREEN configuration. TOP ZONE = Transport mode and
This function enables you to customise an action of measurement check-up. You just have to press shortly on the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software Sirius.
k)

Leds and pushbutton actions fonctionning

The green led is on 2'' when the measurement starts and then flashes each 1' in recording mode.
Specials fonctioning regarding the recorder using mode
Device set up in storage mode
Mode
OFF
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediatly
Mesure
Device set up in transportation mode
Mode
Off
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediatly
Mesure
©JRI Maxant
T° OK (voyant vert) s'allume
pendant 10''.
Témoin d'alarme (rouge)
s'allume pendant 10''.
Pushbutton pressing
Green led 2" = beginning of measurements
Pushbutton pressing
Green led 2" = begining of
Green led 10" = Top zone
To stop your Mini SPY RF BLACK, press between 5 and 10"
on the button:
< 5"
-
Red led 2"
-
-
Green led 10" = auto control
< 5"
-
Red led 2"
measurements
-
AUTO CONTROL = Storage mode.
5''> pressing <10''
The 2 leds are on and flash at the
same time.
-
-
-
-
-
5"<appui>10"
The 2 leds are on and flash at the same
time.
-
-
The 2 leds are on and flash at the same
time = Waiting for starting measurements
The 2 LEDs are on and then flash
alternatively = ending measurements
The 2 LEDs are on and then flash
alternatively = ending measurements
12