Zephyr ARC AHG-00BL Notice D'utilisation page 2

The glass can be installed
either prior to or after in-
stallation of the hood. If the
hood has not been mounted
to the wall, place it on a so-
lid work surface.
2. Undo the (6) wing nuts
securing the glass to the
panel. Fig.2
3. Remove the glass.
A
1. Open the top glass door. See Fig.1
WARNING! Hold the glass to prevent it from falling
after the next stage.
B
- 2 -
www.zephyronline.com
4. Position the glass from the kit
on the door panel by sliding it
until it touches the rear lip ensu-
ring that the pins are within the
slots. Fig.3B
B