Denon Professional DN-470A Guide D'utilisation page 5

Setup
Items not listed under
1. Use the included Euroblock connectors to connect the inputs on the rear panel to your
audio sources.
• Each channel input has a ground (G), cold/negative (–), and hot/positive (+) connector.
2. Use the included Euroblock connectors to connect the outputs on the rear panel to your
loudspeakers.
• Each channel output has a switch for 70V and 100V.
3. Use the included power cable to connect the power inlet to a power outlet.
4. Power on all of your audio sources (Blu-ray
etc.).
5. Press the power switch to power on DN-470A.
6. Adjust the level knobs for each channel input as necessary.
Example
Receiver
SOURCE SELECT
ZONE 2 ZONE 2 ZONE 3 ZONE 3 INFO OPTION
ON/OFF SOURCE ON/OFF SOURCE STATUS DIMMER
ENTER VIDEO
PHONES BACK SETUP
AUX 1
HDMI 7 5V/1A
Introduction
Loudspeakers
MASTER VOLUME
QUICK SELECT
1 CBL/SAT 2 Blu-ray 3 GAME 4 NETWORK
L - AUDIO - R SETUP MIC
AUX 1
IN-Command
S E R I E S
INTEGRATED NETWORK AV RECEIVER AVR-X4000
Blu-ray Player
Box Contents are sold separately.
®
players, stereos, microphones, amplifiers,
Loudspeakers
Power
5