Cycling Cts Kit; Reflectors And Flag Assembly - Chariot X-COUNTRY Série Mode D'emploi

CYCLING CTS KIT

CYCLING CTS KIT

4.0 Reflectors and Flag Assembly

Attach the reflector to the spokes.
Insert orange clip into reflector and over the
spoke. With a slot screwdriver, turn the clip
until reflector is tight and unable to shift.
Attach the red reflector to the left grommet
on the rear of the back storage bag.
PLASTIC CAP
LOCATION FOR
FLASHING CLIP
ON LIGHT
Insert flag into hole located in the plastic
cap on the upper left rear side of frame.
Slide flag down into hole until flag touches
the bottom of the tube.
Note: For additional visibility you may wish
to purchase a battery powered clip-on light
from your local Chariot retailer. This light
can be connected to the top rear of the
fabric sleeve (left side sleeve).
13
13
WARNING:
Read and understand all of the warnings
otherwise injury or death to you or to
your passengers could result:
– Always use safety flag.
– Do not operate the bicycle trailer
without reading and understanding this
manual.
– Use extreme caution while trailering,
never exceed 25 km/h and slow down
to less than 10 km/h around corners
and on rough roads.
– Avoid all obstacles as carriers can tip
over causing serious injuries to the
passenger and cyclist.
– Passenger must always use seat belts
and wear an approved helmet.
– Child must be old enough to wear a
helmet and to sit upright unattended.
Consult pediatrician if child is less
that one year old.
– Child's head, including helmet, must
not protrude above upper frame.
– Never leave child unattended in carrier.
– Do not exceed the maximum capacity
for a single carrier of 75lb (34kg) and
for a double carrier of 100 lb (45kg)
including children and cargo.
– Cyclist must be an experienced,
strong rider.