Transporting Machine; Recommended Stock Items; Trouble Shooting - Nobles ULTRASHINE Manuel Opérateur

TRANSPORTING MACHINE

1. Unplug the power cord and remove the pad from
the machine. Neatly coil the cord around the cord
hook and handle to prevent cord damage.
2. Load the machine using a recommended loading
ramp or carefully lift the machine with adequate
assistance.
FOR SAFETY: When transporting machine, get
assistance when lifting machine.
3. Secure machine with tie--down straps when
transporting by vehicle.
WARNING: Do Not Use Outdoors. Do Not
Expose to Rain. Store Indoors.

TROUBLE SHOOTING

PROBLEM
Machine does not operate.
Machine circuit breaker trips
continuously.
UltraShine Burnisher (06- -03)
CAUSE
Machine is unplugged.
The cord connection between the
handle and the base is not properly
connected.
Machine circuit breaker tripped.
Building circuit breaker tripped.
Faulty power cord.
Faulty wiring.
Faulty On/Off Lever Switch.
Faulty rectifier.
Excessive pad pressure.
Heavily soiled pad.
Improper pad for application.
Faulty circuit breaker.
Worn carbon brushes in motor.
Home Find... Go To..

RECOMMENDED STOCK ITEMS

Refer to the Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description as shown (Figure 10).
FIG. 10
SOLUTION
Plug machine in.
Ensure proper cord connection.
Reset the circuit breaker on machine.
Reset circuit breaker in building.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Adjust pad pressure knob.
Replace Pad.
Change to proper pad.
Contact Service Center.
Contact Service Center.
OPERATION
13