Publicité
Les langues disponibles
Les langues disponibles
Once the unit is plugged in, the air mover can be turned on by rotating the
switch to one of the settings shown below.
O (OFF)
III ( HIGH )
AIR MOVER OPERATING POSITIONS
The air mover may be set in one of two operating positions. Pick
the position best suited for the application.
•
Use the down position (Figure 2) for applications such as: drying wet oors,
shampooed carpets, etc. To use this position simply place unit on its base.
•
Use the up position for applications such as: drying paint on the ceiling.
To use this position, lay the unit on the back side with the front grill pointing
towards the ceiling (Figure 3).
Figure 2
II (MEDIUM)
I (LOW)
Figure 3
UNPACKING AND CHECKING CARTON
CONTENTS
Carefully unpack and inspect Air Mover. Contact customer service if
any parts are damaged or missing.
This Air Mover includes a retractable handle. It is shipped in its locked
lowest position.
Retractable
Handle Down Position
Handle
Locked
Unlock the levers and adjust
handle to desired height
Tightening the Handle:
•
If handle does not hold its position after engaging the lock levers,
unlock the handle so adjustments can be made.
• Slightly tighten the hex nut (A) and re-engage the lock levers.
If still not satisfactory, repeat this step until desired lock force
is achieved. DO NOT OVERTIGHTEN.
Close
A
Open
7
Handle Up Position
Retractable
Handle
Unlocked
Adjust handle to desired
height and lock into place
with levers
Publicité
