Genie 110AFX Mode D'emploi page 8

UK: Operating Manual
Dear customer,
Thank you for purchasing this GENIE quality product. Please carefully read the operating
instructions prior to the initial operation and keep them handy for future reference.
Please pay particular attention to the following safety information. If you have any questions or
complaints about the device, please refer to the service information at the end of these
instructions.
Installations
Plug the shredder into a grounded electrical outlet where it can be easily installed and is accessible.
Connect the power cord to any standard 230 VAC, 50Hz outlet.
NOTE: This shredder will operate only when used with the supplied basket. The supplied basket
has a built-in safety feature which prevents the shredder from operating if used with any other
basket or if improperly assembled.
Setup
1. Place the machine on level ground and plug the power cord into any easily reached grounded electrical
outlet.
2. Make sure the wastebasket is correctly positioned.
3. Slide the switch to the Auto On position.
4. The machine will be ready to operate when the Power On LED indicator is illuminated green.
Operation
The Main Switch is located on the top of the shredder. The Main Switch has four (4) settings.
Forward (FWD): The cutting blades rotate forward and shred paper.
AUTO: The machine is ready for operation. Power light will be on.
Power OFF: The machine switched off. Power light will turn off.
Reverse (REV): The cutting blades rotate backwards and push paper out of the shredder.
Auto feed flap
Auto feed (100 sheets max.)
Auto Feed (paper guide flap)
Manual feed (10 sheets max.)
Main switch
8