Publicité
Les langues disponibles
Les langues disponibles
4. Attaching ring light and battery compart-
ment
Insert the accessory foot (9) of the battery compart-
ment (1) into the camera's hot shoe (a) (fig. E). Rotate
the locker ring (8) to secure the battery compartment
(b).
The battery compartment (1) can also be attached on
a stand, ball head etc. by using the 1/4" tripod thread
situated inside the accessory foot (9).
The light comes with six adapter rings (3) for 49, 52,
55, 58, 62 and 67 mm filter threads. Choose the ap-
plicable adapter ring and screw it in the filter thread
of your lens. Now push the ring light (2) from the top
on the adapter ring (fig. F) and insert the ring light's
connecting cable in the socket marked "OUT PUT" (4)
of the battery compartment (1) (fig. B).
5. Operating the ring light
To switch on the light, set the switch (7) (fig. C) either
on "DC 3V" for mains operation or on "BATT" for bat-
tery operation. Please note that battery operation is not
possible if the unit is connected to the mains adapter.
Please set the switch to "OFF" when the light is not
in use.
If you are observing brightness going down during bat-
tery operation, replace batteries.
For unlimited continuous operation please choose
mains operation.
You can light all 48 LEDs or only the LEDs on the right
side or the left side by setting the switch (11) accordin-
gly (either to "ALL" or "R" or "L") (fig. G).
6. Important notes
Only use the ring light and the battery compartment
with parts designed for them.
Make sure that:
- both water and flammable substances and
liquids are kept away from the unit.
- ring light and battery compartment are not
covered during operation.
Please remove batteries if the ring light is not in use for
an extended time.
Do not open the housing of the light.
Repairs must only be carried out by qualified persons.
7. Maintenance and care
Ring light and battery compartment are maintenance-
free. Make sure, that the front pane of the ring light
is free of stains and dirt. If necessary remove these
before operation. Clean the light and the battery com-
partment with a soft cloth. On no account use petrol or
other cleaning agents and solvents.
8. Specifications
Light source:
48 LEDs
Color temperature: 6000 K ± 500 K
Illumination:
approx. 1550 lux at 30 cm (1 ft.)
approx. 610 lux at 50 cm (1 ft. 8 in.)
approx. 165 lux at 1 m (3 ft. 3 in.)
Angle of coverage: 60°
Minimum working
distance:
3 cm (1.2 in.)
Operating time
with 2 nickel
metal hydrides:
approx. 2.5 hours
Operating voltage: 3 V
Dimensions:
Ring light:
13 x 11 x 3 cm (5.1 x 4.3 x 1.2 in.)
Battery
compartment: 9 x 5 x 5 cm (3.5 x 2 x 2 in.)
Weight:
Ring light with adapter ring: 140 g (4.9 oz.)
Battery compartment: 55 g (1.9 oz.) (w/o batteries)
9. Accessories
3271 Mains Adapter
Input voltage: AC 100 – 240 V
Output voltage: DC 3 / 4.5 / 5 / 6 / 7.5 / 9 / 12 V,
switchable
Maximum output current: 1000 mAmps
Right reserved to make technical modifications.
Publicité
