Assembly And Attachment; Initial Use - Tetra LightWave Mode D'emploi

ASSEMBLY AND ATTACHMENT

The device can be hung on the loop or placed in the holder and attached to the
outside of the clean aquarium wall using the suction cups.
Procedure:
Fig. B
• Attaching the device using the holder: to ensure that the suction cups hold
securely, moisten and use on smooth, grease-free and clean surfaces.
NOTICE: Do not attach the device to the inside of the aquarium in order to
avoid contact with water.

INITIAL USE

An (optional) LightWave Splitter is required to operate two LED lights.
Procedure:
Fig. C
1. Connect all components and connect the power supply to the mains.
NOTICE: Do not attach electric accessories, such as the power supply, to
the aquarium in order to avoid contact with water.
2. When you first switch on the LightWave Timer it will be in set-up mode. Set
the time and functions ( 9, Set-up).
– The set-up menu is exited automatically after 30 seconds of inactivity.
Interrupted power supply
If the power supply is interrupted (e.g. due to a power cut or if the switch on
the power supply is turned off), the current time settings will be lost. Once the
power supply is restored, the LED light will indicate with full brightness that the
power supply has been interrupted.
• In this case, the current time and brightness will need to be reset ( 9,
Set-up).
UK
7