Sharp PS-919 Mode D'emploi page 5

What is included in the box
1 × PS-919
1 × Power Adapter with AC plug
1 × User Manual
1 × Quick start guide
1 × Warranty Card
Panels & Controls
5
6
7
8
9
TOP VIEW
1. button – Press the button to turn on the unit. Long press the
button to turn off the unit.
2. button – Short press: changes the front light mode
Long press (2 sec): changes the side light mode
Longer press (4 secs): switch all the lights off
3. button – Short press the button to toggle between Bass & 3D
surround sound modes:
A. Bass Off , 3D Off - orange LED is off
B. Bass On, 3D Off - orange LED continuously lit
C. Bass Off , 3D On - orange LED slowly fl ashing
A long press of the button will swich off both modes: Bass Off , 3D Off .
4. button – Press the button to turn up the volume. Long press the
button to skip to the next playing track.
5. SOURCE button – Press the button repeatedly to switch the playback
mode: Bluetooth, AUX, USB. A long press of the button will activate
the TWS/Duo mode function.
Note that the USB mode can only be selected if a USB stick is plugged
into the unit.
6. button – Press the button to play or pause the playback. Long
press of the button will disconnect bluetooth connection.
7. button – Press the button to turn down the playing volume.
Long press the button skip to the previous playing track.
8. SOURCE INDICATOR – Switch to Bluetooth mode, the blue light turns
on and starts fl ashing when pairing. Once paired, the blue light stops
fl ashing. Switch to USB mode, the blue light fl ashes rapidly three
times, then goes off , then two seconds later, three times, and so on.
Switch to AUX mode, the blue light fl ashes slowly and continuously
9. BATTERY STATUS INDICATORS
10. 3D/Bass indication – When Bass Off and 3D surround Off LED is Off .
When Bass On and 3D surround Off orange LED continuously light.
When Bass Off and 3D surround On orange LED slowly fl ashing.
11. RECHARGING INDICATOR – When the charger is connected, red light
turns on. When the device is fully charged, the red light turns off .
1
2
REAR VIEW
1. DC 18V – AC Adapter input port.
2. USB PORT – The USB 2.0 5V/1A port allows you to charge your mobile
device from the speakers built-in battery. You can also playback MP3
1
audio fi les stored on a USB device up to 32GB which uses a FAT32 fi le
system.
2
3. AUX IN JACK – Connect other audio devices via a 3.5mm jack audio
3
cable.
4
Operation instruction
10
11
Charging the Speaker
This speaker uses a built-in battery pack. Before using it, charge the
batteries by connecting the AC adapter.
Connect the AC power adapter (supplied) to the DC 18V input port on the
rear of the unit, and then to the wall outlet.
DC 18V
CAUTION: Only use the AC adapter supplied with this device. If you do not use
the supplied AC adapter charging performance could be aff ected and it may
cause permanent damage.
Power On the Speaker
Press POWER ON/OFF button on the top panel of the unit
to power on.
The fi rst time you use the speaker, the "Source indicator" fl ashes blue,
indicating that the unit is in paring mode.
TIPS:
– In order to disable or enable the voice prompts, please press and hold
SOURCE button 3 seconds during power up operation.
– When you power on the speaker again after Bluetooth setup, the unit will
search for the previous paired device. Once found, it will pair with that
device automatically.
Power Off the Speaker
Press the POWER ON/OFF button to turn off the unit.
After 15 mins with no activity/connection the unit will automatically power
off to conserve the battery.
EN EN
3