Parts Included; Mounting Instructions - Philips SDV2940/27 Manuel D'utilisation

SDV2940_27_manualV3.qxd

Parts Included

Mounting Instructions

Wall Mount
5/5/08 4:01 PM
1. SDV2940 Antenna. . . . . . . . . . . . . . . . . . . . . . 1
2. Power supply 120V to 6VDC . . . . . . . . . . . . 1
3. Wall / Mast Bracket . . . . . . . . . . . . . . . . . . . . 1
4. Nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
5. U-Bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
6. Mast clamps . . . . . . . . . . . . . . . . . . . . . . . . . . 2
7. Nuts with lock washers . . . . . . . . . . . . . . . . . 4
8. L-Bracket. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
9. 2" Wood Screws . . . . . . . . . . . . . . . . . . . . . . . 4
10. 20' coax cable with connectors. . . . . . . . . . . 1
11. Weather Boot. . . . . . . . . . . . . . . . . . . . . . . . . 1
12. Power Injector . . . . . . . . . . . . . . . . . . . . . . . . 1
13. Plastic Anchors . . . . . . . . . . . . . . . . . . . . . . . . 4
Determining signal strength
Before Installation determine the best location for optimum
reception. It is important for the antenna to have an unobstructed
path to the transmitter.To determine the transmitter(s) location you
can consult the website http://www.antennaweb.org. For best results
the antenna should be facing the transmitter location.
For indoor wall mount installation:
NOTE: Do all antenna assembly work on the ground before
installing on a wall or an antenna mast.
1. Attach main body to the L – bracket as shown, using cross
fig.1
head screw note the orientation of the bracket. Do not fully
tighten the screw to allow for later adjustment (fig. 1).
2. Using the Wall/Mast bracket as a guide, mark position for the
four 2" wood screws. If possible locate a stud to screw into.
If a stud is not available, use appropriate wall anchors (not
included, available at any hardware store) (fig. 2).
fig.2
Page 5
EN
5