Changing The Blade; Trouble Shooting - WOLFF 067323 Traduction Du Mode D'emploi Original

K
J
Always disconnect the power supply before changing
the blade! Unintended starting of the machine may
cause injury.
03/2012

6.0 Changing the blade

6.1 Removing the blade
Remove the thumb screw (H) of the blade cover, until
covering opens automatically
Press spindle lock.
H
Loosen tension screw (K) with the screw key SW13
supplied. It is a right-handed thread!
Remove flange.
Remove blade and clean the flange prior to re-fitting a new
blade.
6.2. Fitting a new groove blade
Fit only a genuine replacement blade:
#063011 milling blade for profile groove
The fitting of the new blade has to be done the other way.
Insert new blade with attention to moving direction.
Put back on the flange and fix draw spindle (K).
K It is a left-handed thread!
Lower covering
Re-tighten tension screw.

7.0 Trouble shooting

Trouble
Machine does not work
Undue force necessary
to achieve a groove
Excessive vibration
Bad grooving
Parkettnutfräse, #067323
Eventual cause
Power supply
disconnected
Blown fuse
Defective cable or plug
Blade is blunt
Tooth of the blade are
broken
Guirs clogged
Elimination
Have machine
repaired by a qualified
electrician
resp. change parts
Change blade
Change blade
Clean rollers
12