En - English; Important; Correct Use - Miele professional BHM 08 Mode D'emploi

en - English

Important

The face mask holder may only be
~
used in a Miele tumble dryer which has
been specified by Miele as suitable for
its use.
It is essential that you also read the
~
operating instruction manual supplied
with your Miele tumble dryer before
using a face mask holder.
To prevent the risk of damage,
~
please note:
– Do not place other textiles or objects
in the dryer at the same time as
using the face mask holder. Make
sure the drum is empty before
positioning the face mask holder.
– The face mask holder must always
be positioned securely.
– To avoid the risk of overheating only
use with the programme listed on the
following page.
High temperatures can damage face
masks.
– Straps, ties etc. must not come into
contact with the drum or with the
drum ribs in the dryer.
6

Correct use

The mask holder is positioned between
two of the drum ribs and rotates with
the drum.
Only place a maximum of two mask
holders in the drum.
^ See illustrations a, b and c on
page 3.
Face mask retainers a rotate and are
fitted on holder b (see illustration a).
^ After washing, allow water to drip off
face masks and shake vigorously to
dislodge any retained water.
A Secure the face masks to retainers
a on the face mask holder. Masks
with connectors for helmets: Use a
rubber ring (2 supplied) to attach
each helmet connector to its mask
beside it.
B Open the drum door.
C Press push button c on the mask
holder and push the holder together.
Then guide the mask holder into the
middle of the drum.
D Position the holder with face masks
attached between two of the drum
ribs. Make sure it is evenly aligned
with the circumference of the drum.
E Pull each side of the holder out again
until the push button clicks into posi-
tion. Make sure the holder is positio-
ned securely between the drum ribs.
A maximum of two holders at a time
can be used in the dryer.
F Close the drum door.