BEAUTY JATA PS30B Instructions D'usage page 12

NOSE-EAR ACCESSORY
• Place the accessory (2) in the main unit. Insert the groomer into the nostril and rotate in a circular
motion (Fig. A).
• Remove the hair inserting the groomer into the nostril as showed in the drawing (Fig. B)
• In both cases do not insert the unit more than 0,5 cm.
CUT THE HAIR
• To cut the hair it is compulsory to use the accessory (4) together the cutting guides (5 and 6).
• The cutting guide (5) allows a cutting height between 6 and 12 mm. and the cutting guide (6)
allows a cutting height between 14 and 20 mm.
• Insert the guide in the accessory. To assemble the chosen guide place it in the blade and press the
bottom flange of the guide to be inserted.
• Once inserted the guide and keeping pressed the button (7) placed in the lower side, slide it to
leave it in the desired position. The different positions are showed in cutting guide indicator (8).
• Do not use the guide for the final touches.
To get an exact hair cut, and the side burns, nape and the area around the ears with straight lines,
turn the hair clippers round and place them at a straight angle with your head so the blade is in
slight contact with the skin, and shave downwards. This way you will get a perfect finish, as if
shaving.
BEARD
• To cut the beard use the micro shaver and the cutting guide accessory with each guide. If you are
using the micro shaver you can select the cutting height between 1 to 4 mm.
• Always remember you must begin with the cutting guides set to the longest cutting position
before setting it to a lower position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements
upwards and outwards.
• For the final touches and the edges always use the hair clipper without any guide.
MOUSTACHE
• You ca use the micro shaver or the cutting hair accessory.
• Comb the moustache downwards.
• Start with the cutting guide in the high position. Later you may use the shorter cutting guides.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the hair clipper is unplugged from the mains.
• Release the acceosries and use the brush to clean the unit and accesories.
• To clean the shaver, remove the grille by pressing the two buttons placed in the laterals and use
the brush.
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use to clean chemical products or abrasives, metallic scourers and similar, which may
deteriorate the surfaces.
ENVIROMENT PROTECTION
• This appliance is equipped with two Ni-Mh batteries.
• To remove the batteries, follow the next steps:
1.Remove the back cover with a small screwdriver.
2.Release the inner screws of the lid and the screws of the circuit plate placed bellow.
Use some scissors to cut the batteries cables connexion.
• Dispose the appliance according to the local garbage regulations.
• Dispose the batteries according to the local garbage regulations.
• Never throw away the appliance or the batteries to the rubbish. So you will help to
the improvement of the environment.
• The batteries must not be mixed with other domestic residues
12