Publicité
OPERATION (ENGLISH)
POWER REQUIREMENT
Modern 2.5" HDDs with low power requirement may be
operated even without the enclosed PS/2 power splitter
cable. If operation of the HDD is erratric please use the
enclosed PS/2 power splitter cable connected to the PS/2
port of your computer. For HDDs with higher power
consumption (>500mA) it may be necessary to use an
external power supply to power up the HDD in the external
case properly. Please contact LINDY for an appropriate
power adapter.
Driver Installation
Modern operating systems like Windows XP, 2000, ME
already include the necessary drivers if your USB 2.0 Card
is installed correctly and drivers are up to date. If the
external HDD Drive is recognized correctly as a USB 2.0
device please do not install drivers again.
Please refer to the enclosed Software Installation Manual
for installation in other situations.
ANSCHLUSS & BETRIEB (DEUTSCH)
STROMVERSORGUNG
Moderne 2,5" Festplatten mit niedrigen Strombedarf
können in den meisten Fällen ohne zusätzliches
Stromversorgungskabel betrieben werden. Wenn die
Festplatte jedoch nicht einwandfrei funktioniert oder eine
hohen Strombedarf (>500mA) hat, sollte immer das
beiliegende Stromversorgungs-Y-Adapterkabel verwendet
werden. Sollte jedoch ein Notebook nicht in der Lage sein,
die notwendige Versorgungsspannung über den USB- und
PS/2-Port zur Verfügung zu stellen, so kann auch ein
externes Netzteil verwendet werden, z.B. LINDY
Artikelnummer 70224 ( Weitbereichsnetzteil 90-240V, mit
Euro Stecker).
TREIBERINSTALLATION
Moderne Betriebssysteme wie Windows XP, ME, 2000 (mit
installierter USB 2.0 Karte und aktuellen Treibern) haben
bereits alle notwendigen Treiber an Board. Sollte das
externe Laufwerk hier bereits als USB 2.0 Device erkannt
werden und funktionieren, so sollte keine erneute
Treiberinstallation vorgenommen werden. In allen anderen
Fällen gehen Sie bitte vor wie im Software Installation
Manual beschrieben.
UTILISATION (FRANCAIS)
PUISSANCE NECESSAIRE
Les disques durs 2.5" classiques avec une faible
consommation d'énergie peuvent être utilisés sans le câble
d'alimentation Y PS/2 fourni. Si le disque dur se comporte
de manière étrange, veuillez utiliser ce câble.
Pour des disques durs consommant davantage de
puissance (>500mA) il sera nécessaire de connecter une
alimentation externe supplémentaire. Veuillez contacter
LINDY pour les alimentations correspondantes. En général,
les alimentations LINDY pouvant convenir sont les prises
secteur spéciales pour l'Angleterre et l'alimentation 70224
pour le continent Européen à connexion Euro.
Installation du pilote
Les systèmes d'exploitation actuels comme Windows XP,
2000, ME incluent directement le pilote USB 2.0 et il sera
mis à jour automatiquement. Si le disque dur externe est
reconnu correctement en tant que périphérique USB 2.0
n'essayez pas de réinstaller le pilote.
Veuillez vous référer au manuel fourni pour l'installation
des pilotes sous d'autres systèmes.
FCC Warning
This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,
may
cause
harmful
interference
communications. However, there is no guarantee that interference
will not occur in a particular installation.
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
!
Reorient or relocate the receiving antenna
!
Increase the separation between the equipment and receiver
!
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
!
Consult the dealer or an experienced radio/TV technician for
help
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including
interference that may cause undesired operation
For Home and Office Use
Tested to Comply
with FCC Standards
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition - MAR 2003
This
to
radio
If this equipment does
LINDY No. 42910
Publicité
