Publicité
Les langues disponibles
Les langues disponibles
PRMD_notice: notice_PC461/462
On the floor :
• Fix the two casters on each side
of the heater as shown.
• Fix the casters with screw.
On the wall :
• Mark first screw hole on the wall (about 80 cm from floor).
• Drill first hole, then insert first screw anchor into the first hole with a
hammer.
• Put mounting support on the wall and tighten lightly the first screw.
• Mark second hole on the wall by raising the support in parallel to the
floor.
• Drill second screw into the second hole and insert the screw anchor.
• Tighten both screws.
• Fix the feet cover.
• Place the mounting holes of the support at level of screws. The
appliance is fixed.
• Cut the plug from the power cord and connect according to the legislation into force.
• Plug the appliance.
• Turn the power switch (2) on desired position :
position I = 1000 W for model PRMD 1000 and PRMDT 1000
position I = 1000 W or position II = 1500 W for model PRMD 1500 and PRMDT 1500
position I = 1200 W or position II = 2000 W for model PRMD 2000 and PRMDT 2000
• Turn the thermostat (3) to select desired temperature.
• When desired temperature is reached, heater stops automatically.
• If ambient temperature decreases, heater restarts automatically.
• According to personnal needs, temperature can be increased or decreased with the thermostat.
• Anti-frost function keeps the surrounding temperature above "freezing point".
To do this, turn the thermostat to the
The appliance is equipped with an automatic cut-off device in case of overheating.
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a dry cloth.
• Never use abrasives or detergents.
18/04/11
10:42
Page 7
INSTALLATION
OPERATING INSTRUCTIONS
mark.
MAINTENANCE
7
Publicité
