iqonic ZJ-SLT266 Manuel D'utilisation page 6

Precautions
1. During the first use of the product, place the product in a place with sufficient sunlight for
charging. The product can be used after being charged for several hours.
2. When the product will not be used for a long time, please place the product in a place with
sufficient sunlight. In this case the charging time is 1 day. For maintaining battery performance,
fully charge the battery with sufficient sunlight once every month.
3. The charging time and efficiency of the solar panel may be affected by the weather and
installation position. Considering the conversion rate for solar power generation, if the product is
used with good weather, it will gain higher charging efficiency and effectiveness.
4. When there is sunlight and other lights, and if the power switch is OFF, the LED lamp will not be
lightened in day and night.
5. The solar lamp should be installed in a place with sufficient light to ensure the solar panel will
absorb sunlight sufficiently, so that the solar lamp will work for more time.
6. The angle of the solar lamp and the direction of the light should be adjusted to the best position.
The recommended height is 2-3m.
7. During winter or when there is little sunshine it is recommended to use the lamp in mode 1.
Product usage
Press and hold the ON/OFF button for 2 seconds to turn on the lamp. The lamp will now flicker a few
times and will be turned on. The lamp is now configured in mode 1. See below for the functionality of
each mode and instructions for changing the lamp mode.
Mode 1: Motion Sensor
In this mode the lamp reacts to movement. For example, when people pass. The lamp turns off after
15 seconds if during this time period no movement has been detected.
Mode 2: Motion Sensor + Dimmed Light
Press the ON/OFF button shortly once
In this mode the lamp is always on with dimmed light. The light turns brighter when the motion
sensor detects movement. The lamp turns off after 15 seconds if during this time no movement has
been detected.
Mode 3: Dimmed Light
Press the ON/OFF button shortly twice
In this mode the lamp is always on with dimmed light. The motion sensor is disabled. The light
intensity does not change when someone passes.