Remote Controller - MAXA MI 2.6 Série Manuel Utilisateur Et Installation

■

REMOTE CONTROLLER

◊ Remote control specifications
Model
Rated voltage
Lowest voltage of CPU Emitting Signal
Reaching distance signal range
Environment
◊ Introduction of function buttons on the remote controller
NO. PART
DISPLAY
POWER ON/OFF
TEMP
MODE
TIMER OFF
TIMER ON
FAN
HOUR AND MINUTE
VERTICAL LOUVERS
STEPPING
HORIZONTAL
LOUVERS
SLEEP
CLOCK
RESET
1) ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit operation.
2) CLOCK SETTING
1. Press "CLOCK" to set the correct time: the display of remote controller will
flicker "CLOCK".
2. Press "HR": time setting changes by an hour from AM(0-12)~PM(0-12).
Press "MIN": time setting changes by one minute from 0~60. Press CLOCK
again to save the setting.
3) SETTING THE OPERATING MODE
Each time you push the
HEAT and FAN, as the following figure indicates:
: automatic mode
A
: cooling mode
: dehumidification mode
: heating mode
: fan only mode
All the available settings under each mode are as follows:
3.0 V (Alkaline dry batteries LR03 X 2)
2.0 V
8 m (when using 3.0 voltage, it gets 11 m)
-5°C ~ 60°C
FUNCTION
Used to switch the unit on and off.
Used to set the desired ambient temperature.
Used to select Auto / Cool / Dry / Fan / Heat
operation.
Used to set timing for time OFF.
Used to set timing for time ON.
Used to select fan speed:
Auto/Low/Medium//High.
Used to set clock and time setting.
Used to set air flow vertical direction.
Used to set air flow horizontal direction.
Used to set/cancel the Sleep mode regardless
of the operating mode of the conditioner.
Used to set the current time.
Used to reset the controller back to normal
condition.
button, a mode is selected in a sequence ranging from AUTO, COOL, DRY,
A
R8060804520
2
4
7
9
10
12
1
3
5
6
8
11
13
Fig. 1
14