I.SOUND Stage 360 Guide De L'utilisateur page 4

Assembly for the Stage 360°
1. Remove all contents of the Stage 360° om the box
including the screw, 2 rubber washers, and assembly tool for
the base.
2. Remove the plastic circular shell (labeled #4) om the metal
circular base of the Stage 360°.
3. Place the two circular rubber washers (labeled #3) onto the
back of the plastic circular shell around the center of the shell.
4. Gently insert the plastic circular shell inside the metal
circular base (labeled #2).
5. Gently place the neck of the Stage 360° (labeled #5) into the
top of the plastic circular shell.
6. While holding the plastic circular shell and neck of the Stage
360°, carefully turn the Stage 360° upside down, and insert the
screw (labeled #1) into the hole at the bo om of the Stage 360°.
7. Use the assembly tool to gently tighten the screw clockwise
until the screw is secure.
NOTE: The neck of the Stage 360° is designed to allow the
device to turn 360° around. Do not tighten the screw too tight
to allow the Stage 360° to turn 360°.
8. Once the neck of the Stage
360° has been securely a ached
with the screw, place the Stage
360° on a at surface.
9. With one hand, press and hold
the two bu ons at the top of
Stage 360° neck. With your other
hand, hold the device bracket
(labeled #6) with the circular
opening facing the Stage 360° and
align with top of the Stage 360°