Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 fitting brackets
- 2 threaded fasteners M6
- 4 « silent block » with steel spacer
- 1 central part
- 2 plastic washers Ø5
- 2 pieces of railings
Fitting instructions
- Aluminium railings are in option. You can fit them at the air intake
Level at the front of the belly pan with silicone.
- Remove the 3 screws securing the output gear cover and move it up
(photo 1).
- Place the fitting brackets as shown on pictures 2 and 3.
2
- Replace the output gear cover.
- Mount the « silent block » on both lateral parts of the belly pan. The steel spacers shall be fitted inside of the
belly pan. Assemble the 3 parts of the belly pan with the screws BHc 5×15, the plastic washers Ø5 and inserts
M5. The central part has to be fixed inside both other parts.
- Screw the left side with 2 screws BHc 6×20.
- Screw the right side with the screw BHc 6×20 at the rear and the screw 6×30 at the front, by inserting the
plastic spacer between the bracket and the belly pan.
Once fitted, the belly pan must have no contact with engine and has to be far enough
from complet exhaust system. Fitting brackets' angles may be a little modified in
order to adjust the accessory to every motorbike (do not fold the fixing brackets while
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
ON MT 07 2014 / MT 07 TRACER 2016 / XSR 700 2016 → ∞
(7cm x 11cm for MT - 5cm x 11cm for XSR)
fitted on belly pan).
ERMAX BELLY PAN ADAPTABLE
- 3 screws BHc 6×20 black big head
- 1 plastic spacer Ø6 L: 10 mm
- 1 screw BHc 6×30 black big head
- 2 screws BHc 5×15
- 2 inserts M5
3
« CAUTION »
FITTING INSTRUCTIONS
Estimated fitting time : 1 hour
1
EN
Publicité
