Cleaning The Tank - air&me GOTA Guide D'utilisation

MAINTENANCE
• Make sure the unit is turned off and unplugged before handling.
• Do not immerse the device in water or any other liquid.
• Do not use corrosive, abrasive or flammable products to clean the unit.
CLEANING THE TANK: To avoid scale deposits, clean the tank at least once a month with a
suitable product or white vinegar. To do this, remove the tank from the unit and remove the
cap, then fi ll it with water and cleaning agent. Let stand for 15 minutes, then empty and rinse
the tank thoroughly with clean water before putting it back in place and turning on the device
again.
CLEANING ULTRASONIC PLATE : Dry the ultrasonic plate and clean it with a soft brush. Then wipe
it with a soft cloth.
STOCKAGE: To avoid any bacteria or virus proliferation, never store the appliance with water
inside the tank and be sure that the appliance is perfectly dry.
1. Empty and clean the tank.
2. Clean the pre-fi lter.
3. Store the product in a place that is protected against dust and that is clean and dry.
ACCESSORY
FILTRATION CARTRIDGE
To discover at www.airandme.fr
The fi ltration cartridge reduces calc depo-
sits. It screws itself inside the tank cap and
stays immersed in water. It should be re-
placed once or twice a year depending on
usage and water hardness.
14
FAQ
Circumstance Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
The product
electrical system of your
does not work
house.
> The tank is empty.
> The tank is not properly
placed.
> The humidity level chosen on
The power
the electronic hygrostat or
indicator is lit, but
via HygroSmart
the appliance ®
does not
> The power variator is at a
produce steam
minimum.
at the outlet
> There is not enough water in
the tank.
Abnormal noise
> The device is not on a stable
surface.
> The appliance tank must not
be fi lled from above.
> The tank cap is not properly
The appliance
closed.
leaks
> The seal of the tank cap has
fallen off during fi lling.
> The product is new.
Moisture
produced has an
> The water in the tank is dirty
unpleasant smell
(stagnant or contaminated).
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Fill the tank.
> Push and place the tank properly.
is reached.
> Check that the power converter is
not at a minimum.
> Add water to the tank.
> Position the tank on a fl at and stable
surface.
> Fill the tank as indicated.
> Tighten the tank cap securely.
> Replace the seal in the cap.
> Empty the tank and base and wash
and dry both parts before turning
the unit on again.
15