Publicité
Les langues disponibles
Les langues disponibles
3
Applications
In combination with the multifrequency receiver
US-903DCPRO / 5 from JTS, this dynamic hand-
held microphone with integrated multifrequency
transmitter creates a wireless audio transmission
system The wireless microphone operates with
four groups (A – D) to which 16 transmission
channels are assigned, i e altogether 64 facto-
ry-set transmission channels are available These
channels in the UHF range of 518 – 542 MHz can
be selected as desired
The microphone is equipped with a micro-
phone case, a microphone holder and coloured
push-on plas tic rings for identification of the
microphone
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the product MH-8800G / 5 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
CZ
IT
The regulations of the country where the prod-
uct is operated must always be observed Prior
to operating the product, please contact the
MONACOR subsidiary or the corresponding
authorities of the respective country Links to
the national authorities can be found via the
following Internet address:
www cept org
t ECC
t Topics
t Other spectrum topics: SRD Regulations
and indicative list of equipment sub-classes
t EFIS and National Frequency Tables
EL
FI
FR
LT
MT
PL
4
Power Supply
•
Only insert batteries of the same type and
always replace all batteries
•
If the microphone is not used for a longer
period (e g more than a week), remove the
batteries Thus, the microphone will not be
damaged in case of battery leakage
1) Unscrew the cap (7) for the battery compart-
ment
2) Insert two 1 5 V batteries of size AA (R6) with
the positive and negative poles as indicated
on the holder
3) Place the battery compartment cap straight
against the thread of the microphone body
and screw it on
Never put batteries in the household
waste Always dispose of the batteries
in accordance with local regulations
5
Setting the Microphone
into Operation
1) Before switching on the microphone, set the
re ceiver to an interference-free transmission
channel, see instruction manual of the re-
ceiver
2) Then switch on the microphone: Set the
POWER switch (9) at the lower end of the
microphone to the position POWER If re-
quired, slide the safety cap (10) downwards
beforehand The display will indicate the
group adjusted with the corresponding trans-
mission channel (3) and a battery symbol (2)
will indicate the current charging status of
the batteries in several steps:
fully charged
3) The buttons (4 – 6) which are slightly recessed
can easily be actuated by means of the tip of
your thumb without any further aid
4) Set the microphone to the group and the
transmission channel adjusted on the receiver
chapter 5 1
☞
discharged
9
Publicité
