Ermax AEROMAX Notice De Montage page 2

Fitting kit
- 4 BHc 6x20 screws
- 4 BHc 6x15 screws
- 4 rubber washers
- 2 Ø6 threaded staples
Assembly
- Remove the side covers from the headlamp. Attach the new fixing cockles to the screen using the 4
6x15 screws, rubber washers and nuts.
- Position the screen with attached cockles by inserting the spacers between cockles and headlamp
bracket, at the level of front holes.
- Do not tighten completely until you have made the right centring of the screen.
- For 2008 model, remove the screen original fixing brackets and use the staples to replace the brackets
thread.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 2 Ø6 L 5 mm spacers
- 4 nuts M6
- 2 fixing cockles
« CAUTION »
FITTING INSTRUCTION
« AEROMAX NOSE SCREEN »
GSR 600 2006 → ∞
Position of spacers