PCM GSC-807 Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and then tighten the 2
screws of fixations (Important, make sure
that the screws have the same strength of
tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC-807
3.
4.
MARK : Never use the tool holder with
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
GSC-807 Mode d'emploi 1-
BT
Validation :25.04.16
During the mounting or the dismounting of
your cutting tools, block the broach on flats
planned for that purpose, using the
supplied spanner.
The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet.
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
empty positions. Use the supplied
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document :
Page : 2 de 4
office@pcm.ch