Télécharger Imprimer la page

GE GFA24KITL Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

STACKING THE WASHER AND DRYER
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
local electrical inspector's use.
IMPORTANT
codes and ordinances.
Note to Installer
instructions with the Consumer.
Note to Consumer
future reference.
• Service must be performed by a qualified installer.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of the installer.
GE APPLIANCES STACK KIT
Order on-line at GEApplianceParts.com, 24 hours
a day or by phone at 877.959.8688 during normal
business hours.
Part Number
Accessory
GFA24KITL
Complete Stack Kit
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
WARNING
Keep flammable materials and vapors, such as gasoline,
away from dryer.
Place dryer at least 18" (46 cm) above the floor for a
garage installation.
Failure to do so can result in death, explosion, or fire.
• Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
1" either side
3" front and rear
1" top
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches of
open area. If the closet contains both a washer
and a dryer, doors must contain a minimum of 120
square inches of open area.
Installation Instructions
– Save these instructions for
– Observe all governing
– Be sure to leave these
– Keep these instructions for
- Explosion Hazard
MINIMUM CLEARANCE OTHER
THAN ALCOVE OR CLOSET
INSTALLATION
Minimum clearance to combustible surfaces and
for air opening are: 1" both sides, 3" rear and 1" top.
Consideration must be given to provide adequate
clearance for installation and service.
KIT CONTENTS (GE APPLIANCES
KIT # GFA24KITL)
Screws (2) Long
For dryer
attachment
Bracket-
stack (R)
TOOLS YOU WILL NEED
Phillips
screwdriver
Level
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay the
dryer down on its side. Continue using the carton to
protect the finished floor in front of the installation
location.
2
Bracket-
stack (L)
Screws (6) Short
For washer attachment
Gloves

Publicité

loading