COMPLIANCE INFORMATION
The next few pages contains FCC and Canada
compliance information for MicroPod Bluetooth
Please take attention that changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This device complies with Industry
Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This equipment should be installed and operated with a minimum distance 20 cm between the radiator and
your body. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec
une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut
choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
20
重要安全指示:
1、
阅读这些指示
2、
保存这些说明
3、
注意所有警告
4、
遵守所有指示
5、
不要在近水处使用本设备
6、
仅用干布清洁本设备
7、
不要堵塞任何通风口,按照制造商的指示进行安装。
8、
不要安装在热源附近,例如散热器、热风调节器、火炉或其
它产生热量的设备(包括放大器)。
9、
防止电源线受踩踏或挤压,特别是插头处,插座处及其设备
出口处。
10、 仅使用制造商指定的附件/配件
11、 只能使用由制造商指定或随设备销售的推车、支架、三脚
架、架子或桌子。使用手推车时,请小心移动车/设备组
合,以免因翻倒而受伤。
12、 雷雨天或长时间不使用时,请拔下插头。
FOR YOUR SAFETY
For your safety and protection
of your MicroPod Bluetooth
21