Setup & Operation - Haussmann Xpert PNT180 Manuel De L'utilisateur

SETUP & OPERATION
INSTALLING AN ACCESSORY (Fig.3)
1. While the air hose is disconnected from the tool, hold the output shaft (3) with a
13mm wrench (sold separately), and unthread the cap screw (1) using the hex
wrench. Remove the cap screw and retainer (2).
2. Install the desired accessory in any one of seven orientations by aligning two of
the holes in the accessory over the two prongs on the output shaft.
!
Note: When attaching the angled cutting blade accessory, orient the accessory as
shown above so the cap and scraw (1)will be out of the way when working.
3. Replace the retainer (2) and cap screw (1) while holding the blade. Hold the
output shaft (3) with the hex wrench, then tighten securely using the hex wrench.
!
Note: For sanding, first attach the sanding pad to the tool, then align a sheet of
sand paper over the pad and press into place.
4. Attach the air hose from the air source. While holding the air tool firmly in one
hand and the other safely out of the way of the accessory, turn the air source on.
CHANGING ACCESSORIES
Replace accessories when they become worn or damaged.

Remove the cap screw (1) and retainer (2) using the hex wrench. The

accessories can be mounted in 7 different positions at 30° increments. Mount the
blades facing forward.
!
WARNING! The blades are sharp. Use care when handling the blades.
OPERATING THE AIR-POWERED MULTI-PURPOSE TOOL
1. To begin use, push the safety catch forward while squeezing the trigger lever. A
stable two-handed grip on this tool is best.
2. Adjust pressure on the trigger lever to change the speed of the tool.
3. Address the material with a smooth steady stroke of the tool.
!
Note: Do not force the tool. Let the tool do the work.
4. If the tool requires more force to accomplish the task, verify that the tool receives
sufficient unobstructed airflow (CFM) and increase the pressure (PSI) output of
the regulator up to the maximum air pressure rating for this tool.
WARNING: To prevent tool and accessory failure, resulting in injury, do not exceed
!
the tool's maximum air pressure rating of 90 PSI. if the tool still does not have
sufficient airflow, then a larger tool may be required.
5. Do not remove the safety catch. It has been included for your safety. Without it,
the tool could activate when it is bumped against something, set down on its
trigger lever, or picked up while accidently pressing on the trigger lever,
activating the tool.
21