Start-Up; Technical Data - easymaxx KA-SA03 Mode D'emploi

EN
2. Securely clamp the motion detector on the hanging fi xture
using the recess on the back.
3. Use the spherical joint of the hanging fi xture to set the cor-
rect position.

Start-up

1. As soon as batteries have been inserted in the motion de-
tector, it will switch to standby mode.
2. To switch the motion detector and alarm on, press the On/
Off switch on one of the remote controls. The green LED
will illuminate and you will hear a beep sound.
3. The alarm has now been activated. Leave the room within
20 seconds to prevent the alarm from being activated.
4. If the motion detector detects movement, the red LED will
fl ash and a continuous loud beep will be emitted for ap-
prox. 40 – 50 seconds.
5. The alarm will then switch back off, but the motion detector
will remain in alarm mode and trigger the alarm again if
further movement is detected.
6. To switch the alarm and motion detector off, press the On/
Off switch on one of the remote controls again. The motion
detector will switch back to standby mode and the alarm
can no longer be triggered.

Technical data

Product number:
Model:
Voltage supply:
– Motion detector:
– Remote control:
18
Z 01913
KA-SA03
6 V DC (4x 1.5 V type AA)
4.5 V DC each
(3x 1.5 V, type LR44/AG13)