Operating Your Microwave Oven - Impecca CM-0774 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING YOUR MICROWAVE OVEN

Before operating your microwave oven, be sure to familiarize yourself with the safety precautions
in the previous sections. In addition, please review the UTENSILS AND MATERIALS GUIDE and
COOKING TECHNIQUES sections covered in the next sections of this manual.
SETTING THE CLOCK
1. Press the CLOCK button. Colon will flash
2. Use the number pads to enter the correct time.
3. Press the CLOCK button again. Colon will be steady.
NOTE: This is a 12 hour clock. When the oven is first plugged in or when power resumes after a
power interruption, the display will show ENTER CLOCK TIME. If you prefer to not have the clock
displayed, press the RESET button.
You can check the clock time while cooking is in progress by touching the CLOCK button.
SETTING THE OVEN TIMER
1. Press the TIMER button.
2. Enter the amount of time by using the number buttons. The maximum amount of time you
can set is 99 minutes and 99 seconds.
3. Press the START/STOP button.
NOTE: Time countdown can be seen in the menu display for 5 seconds before clock or cooking
time is returned to display. Press the TIMER button and then press the RESET button to cancel
the TIMER process.
SETTING A COOKING PROGRAM
A. One-stage Cooking
1. Press the POWER button. If you want to keep the power at 100%, continue to step 2. Other-
wise, press POWER again, dropping 10% power with each press, all the way down to level 1
(10% total power).
2. Press the numbers on the Number Pad (0-9) for the desired amount of time (in seconds).
3. Press the START/STOP button to begin the cooking process.
B. Two-stage Cooking
Some recipes require different stages of cooking at different temperatures.
1. To set STAGE 1, follow steps 1 and 2 in "One-stage Cooking". Do not press the START/STOP
button.
2. To set STAGE 2, press the COOK button and then enter the desired cooking time and power
level. (Most 2-stage recipes use lower power for second stage.)
3. Press the START/STOP button.
9

Publicité

Table des Matières
loading

Table des Matières